EDGE ELEMENTS
A 3D printed edge element for a viaduct, built as a scale prototype for Mobilis.

1 / 4
Along the edge of a viaduct or bridge runs an edge element: the strip that finishes the deck and carries the railing. Usually it is concrete or a polyester composite — heavy, labour-intensive, and for that reason much the same everywhere in practice.
With a printed element that limitation falls away. No mould is involved; a 3D model is enough. A different radius or a different curve therefore costs nothing extra, while with concrete that is exactly where the cost sits. The more variation a structure calls for, the sooner printing pays off.
This prototype was printed at 1:20 scale in recycled PET-G with glass fibre filling. The outside is a continuous skin; inside it sits a truss of diagonal ribs that carries the load. All the material is where it is needed and nowhere else. That build-up cannot be made with a mould — with a print head it can.
Lighter at the edge means more than less weight in that one spot: the structure beneath it can be sized more efficiently too. And at the end of its life the element goes back through the grinder, to be printed again.
The research grew out of an application to the TBI Klimaattrein, in which ShapeService and Mobilis together examined what large-format 3D printing can mean for edge elements — structurally, but also in terms of sustainability and environmental impact. On cost it worked out favourably, with the low weight and the freedom of form as its strongest cards. And the technique scales up: with two printing robots, 35 metres of viaduct edge can be made in about a week and a half.