SPARK DECK SECTIONS
Printed deck sections for a footbridge in Den Bosch, made from a compound of recycled fruit crates developed for SPARK Campus.

1 / 5
In the Westerpark in Den Bosch there is a footbridge. SPARK Campus, together with Avans Hogeschool and the municipality of Den Bosch, looked into whether the deck of such a bridge could be made from recycled plastic.
That research produced a compound of its own: polypropylene from discarded fruit crates, mixed with glass fibre — strong, flame-retardant and UV-stable. The material was ready. What did not yet exist was a design that could be printed and a printer to make it on. That is where ShapeService came in.
The deck section is hollow: a walking surface and a bottom plate, connected by internal webs. The material is where it carries the load and nowhere else.
The sections are printed upright — the cross-section is the path the print head travels, and the length of the section is the height of the print. They are also printed in pairs, joined together, and separated afterwards. That sounds roundabout, but it is in fact quicker. A fresh layer needs a moment to set before the next one goes on top, and with a single narrow profile that circuit is so short that the printer would have to wait. Two sections at once makes the path twice as long, and so gives every layer twice as much time — without standing still for a second.
The sections are in the bridge. A bench was printed from the same material and stands beside it.